Techno Stick

Article nr	Name	Content
T638001	Techno Stick Steel 56g	56g
T638002	Techno Stick Aluminium 56g	56g
T638003	Techno Stick Water 56g	56g
T638005	Techno Stick Wood 56g	56g
T638006	Techno Stick Titan 57g	57g

TECHNO STICK STEEL/ALU/WATER/COPPER
Physical state: pasty
Colour: various
Odour: characteristic
Flash point: > 100°C
Density: 1,9 - 2,09 g/cm³
Water solubility Immiscible
Curing time: 8 - 12 minutes
Full strength: 24 hours
Working temperature: 10°C to 30°C
Mix rate: 1:1
Gap filling: 15 mm
Shrinking: 0,05 %

TECHNO STICK WOOD
Physical state: pasty
Colour: grey
Odour: characteristic
Flash point: > 200°C
Density: 1,85 g/cm³
Water solubility: practically insoluble
Curing time: 8 - 12 minutes
Full strength: 24 hours
Working temperature: 10°C to 30°C

Mix rate: 1:1
Gap filling: 15 mm
Shrinking: 0,05 %

TECHNO STICK TITAN
Physical state: solid
Colour: brown
Odour: inconspicuous
Initial boiling point and boiling range: > 35°C
Flash point: > 100°C
Vapour pressure: < 0 kPa
Density (20°C): 1,9 g/cm³
Water solubility: Immiscible
Drying time:at 20°C: treatable after 1 hour (35%), after 4 hours mechanically loaded (50%), final strength after 48 hours (100%).
For further information consult Safety Data Sheet or Technical Information Sheet
Temperature resistance: -35°C to +280°C (peak 300°C).
Tensile shear strength: 7,5 N/mm².
Pressure resistance (DIN 53281-83): 80 N/mm².
Chemical resistance: most acids, oils, alcohols, fuels, esters, water,...
For further information consult Safety Data Sheet.

USE:
- Aluminium: Repairing incorrectly drilled boreholes, holes in pipes, cavities and all cracks in metal, wood and plastic. Mechanical working is after a short time possible. Parts can be ground, milled, bored and painted over.
- Wood: Useful for repairs of wood products like planks, furniture, boards and plywood, particle boards, wooden flooring, wooden applied products.
- Water, Copper, Steel and Metal, Titan: Repairs in industries, workshops, marine, automotive, construction and also household use.
TECHNO STICK Steel/Metal has excellent machinability like drilling, tapping, turning, milling etc. after curing. It can be painted or sanded.
APPLICATION:
- Water, Copper, Wood, Steel and Metal and Titan: Make the application surface clean, dry and free from dust, rust, oil etc. If the surface to be applied is smooth, roughen it with sand-paper for better adhesion. Wear protective eye glasses and hand-gloves whenever necessary. Cut the required quanitiy of TECHNO STICK. Mix the putty homogeneously and apply the mixture immediately on the surface to be bonded. Apply pressure to hold the surface unti the adhesive cures.
- Aluminium: The parts to be repaired must be clean and oil and grease-free. Roughening increases the strength of the bond. Cut off the required quantitiy of TECHNO STICK and knead it for approximately 2 minutes until an even colour has been produced and the material becomes warm. Then apply TECHNO STICK to the parts and mould it. Mechanical working can be done after approximately 20 minutes. Final hardening occures after 24 hours. Do not work at outdoor temperatures below 5°C.